Draw the load, shear, and moment diagrams for an overhang beam with a triangular and uniform load. q=6000N/m
Solution: Below is the solution of this problem. You can download the solution
For a cantilever beam with an upturned end, draw the load, shear, and moment diagrams. F1=4000N, F2=2500N.
Solution: Below is the solution of this problem. You can download the solution
Draw the load, shear, and moment diagrams for the illustrated single overhang beam with a uniform and concentrated load. (Note: Single overhangs develop two points of possible Mmax ). F=1200N, q=200N/m
Solution: Below is the solution of this problem. You can download the solution
5-64. The device serves as a compact torsion spring. It is made of A-36 steel and consists of a solid inner shaft CB which is surrounded by and attached to a tube AB using a rigid ring at B. The ring at A can also be assumed rigid and is fixed from rotating. If the allowable shear stress for the material is Tallow =12 ksi and the angle of twist at C is limited to 30, determine the maximum torque T that can be applied at the end C.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
5-63. The device serves as a compact torsional spring. It is made of A-36 steel and consists of a solid inner shaft CB which is surrounded by and attached to a tube AB using a rigid ring at B. The ring at A can also be assumed rigid and is fixed from rotating. If a torque of T= 2 kip • in. is applied to the shaft, determine the angle of twist at the end C and the maximum shear stress in the tube and shaft.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
5-62. The two shafts are made of A-36 steel. Each has a diameter of 1 in., and they are supported by bearings at A, B, and C, which allow free rotation. If the support at D is fixed, determine the angle of twist of end A when the torques are applied to the assembly as shown.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
•5-61. The two shafts are made of A-36 steel. Each has a diameter of 1 in., and they are supported by bearings at A, B, and C, which allow free rotation. If the support at D is fixed, determine the angle of twist of end B when the torques are applied to the assembly as shown.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
*5-60. The shaft is made of A-36 steel. It has a diameter of 1 in. and is supported by bearings at A and D, which allow free rotation. Determine the angle of twist of gear C with respect to B.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
5-59. The shaft is made of A-36 steel. It has a diameter of 1 in. and is supported by bearings at A and D, which allow free rotation. Determine the angle of twist of B with respect to D.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
5-58. The motor delivers 40 hp to the 304 stainless steel solid shaft while it rotates at 20 Hz. The shaft has a diameter of 1.5 in. and is supported on smooth bearings at A and B, which allow free rotation of the shaft. The gears C and D fixed to the shaft remove 25 hp and 15 hp, respectively. Determine the absolute maximum stress in the shaft and the angle of twist of gear C with respect to gear D.
Solution: Below is the solution of this problem. you can download the solution. Get Problem Solutions
